XXX4Fans
curiousmarc from patreon

curiousmarc

patreon


curiousmarc posts

And we have TV from the Moon!

curiousmarc post And we have TV from the Moon! from patreon

A small step for CuriousMarc & Team, but a giant leap for the Apollo communications restoration project. We just transmitted a black and white TV picture using the original Apollo microwave equipment. 

Here is the setup. Our repaired NASA PM transmitter, PM receiver and FM receiver on the left, earth side. We'l...

View Post

Nevada Haul

curiousmarc post Nevada Haul from patreon

https://youtu.be/z0mXPbxbMiI

I'm just back from a trip to Nevada where I attended the Nevada swap meet and met with awesome Patreon John L., who once again saved and donated rare vintage equipment to the channel. Here is a preview of all I got!

M...

View Post

Hewlett-a-Sketch with a HP 7035B X-Y recorder

curiousmarc post Hewlett-a-Sketch with a HP 7035B X-Y recorder from patreon

Disabled viewer Kevin Counihan had donated a HP 7035B plotter to the channel a while ago. I finally got to it, because I needed it to plot curves for an audio filter I made for the Apollo setup. 

It did not work at all at first. A shorted cap replacement later, and it worked for a while before stuff started to go s...

View Post

Power RF components donation for Apollo testing

curiousmarc post Power RF components donation for Apollo testing from patreon

We just received a these hefty RF components, donated by R&D Microwaves. These are two 100 W loads, a 200W directional coupler, and a 30 dB 100W attenuator. R&D Microwaves is a company in New Jersey that makes specialty RF passive components. Check them out at www.rdmicrowaves.com. Michael Antkowiak runs the business,...

View Post

Tek 222 Oscilloscope Video Early Access

curiousmarc post Tek 222 Oscilloscope Video Early Access from patreon

I got a bogus copyright claim on my next video about the fantastic Tektronix 222 mini oscilloscope. Always annoying. But let's turn this into an opportunity and give the Patreons early access while this is resolving!

https://youtu.be/HlYOgXKnHvI

...

View Post

Nice video about the IBM 360

curiousmarc post Nice  video about the IBM 360 from patreon

Not my video, but we have collaborated with the CHA channel in the past. This one has some footage of “my” IBM 360/50 that I had not seen before, as well as the footage of the NASA RTCC in Houston from the Apollo times.

Marc

View Post

Will be on Keysight’s “Live from the lab” Thu. May 19, 9 am Pacific

Well that would be later today in my time zone as it’s past midnight. Sorry for the late notice, I just found out myself about the live chat part. They’ll show a video they shot in my lab and I’m supposed to be on the chat. Register here (free of course):

2022-05-19 07:40:24 +0000 UTC View Post

Clutch job on the big IBM tape drives

curiousmarc post Clutch job on the big IBM tape drives from patreon

The IBM 729 vacuum column tape drives at the Computer History Museum need our help again. I am working on a tape that won't load because of a mechanical problem, and Ken is working on one that won't load because of an electrical problem. These are major repairs, they have been going on for over a month.

We think my prob...

View Post

The Cutest Tektronix O'scope

curiousmarc post The Cutest Tektronix O'scope from patreon

Meet my new old Tektronix 222. It's a classic early digital scope from 1988. At 2 channels, 10 MHz, 8-bit sampling at a rather pokey rate, it's not a screamer even for the time (my monster Tek 7854 samples to 10 GHz!). But it's so small and portable and easy to use.  The CRT display clocks in at an adorable 2" wide, extr...

View Post

Stanford Dish Visit

curiousmarc post Stanford Dish Visit from patreon

Well, wouldn't you know it, Steve M., the current engineer for the nearby SRI space antenna, better known as the Stanford Dish, is watching the channel. This thing is a mere 10 minutes from where I live, and I had always wondered about it. So imagine my surprise when Steve recently contacted me, wondering about the role of th...

View Post

Teletype Model 31

curiousmarc post Teletype Model 31 from patreon

This footage is courtesy of Patron John L. He recently got a Teletype Model 31 going. He told me it is a small portable teletype originally meant for airplane use. It prints on a narrow 1/4 inch ribbon. Congrats John, it looks spectacular!

View Post

Opening the Apollo Pre-Modulation Processor

curiousmarc post Opening the Apollo Pre-Modulation Processor from patreon

We just opened the PMP, or premodulation processor box. It's the box that comes after (or before, depending how you look at it) the transponder. It is described by Collins as the heart of the system. It is in charge of modulating and demodulating all the sub-carriers. It's of pretty spectacular construction.

2022-03-15 22:20:37 +0000 UTC View Post

NASA PM Tx back on Apollo frequency, link double-locked

curiousmarc post NASA PM Tx back on Apollo frequency, link double-locked from patreon

There are a lot of good looking vintage green lights in the lab tonight. We have just successfully returned the NASA PM transmitter to its original Apollo frequency. Our Apollo transponder now locks onto our NASA test PM transmitter uplink, and our PM receiver phase locks on the spacecraft transponder downlink. Solid double l...

View Post

Apollo S-Band SDR Reboot

curiousmarc post Apollo S-Band SDR Reboot from patreon

Many of you have asked how one would redo the Apollo link with modern electronics. And I believe one of the nicest way to do it would be using SDR (Software Defined Radio) technology. At least for the ground station where your electronics are not sensitive to radiation, and you can use the best and latest.

The SDR conce...

View Post

The Apollo PM receiver is back on its original frequency!

curiousmarc post The Apollo PM receiver is back on its original frequency! from patreon

We finally received the crystals from Laptech in Canada. Frequency is right on the money (new one at left, the old one at the "wrong" frequency at right). They were spec'ed at +/- 10 ppm and we got -1.8 ppm!

The realignment of ...

View Post

Another vintage components donation

curiousmarc post Another vintage components donation from patreon

A viewer that wishes to remain anonymous rescued a batch of old components from the dumpster of his company. And they are quite interesting. They are mostly from the early 60's. Early Germanium semiconductors for the most part, mostly professional / higher end. I don't have much Germanium stuff in my collection, so this turns...

View Post

Monster E&L Breadboad System

curiousmarc post Monster E&L Breadboad System from patreon

Thanks to your support, I just got a big bad vintage solderless breadboard system off eBay. Actually, two of them.

We use breadboards quite a bit in the lab, and when there are several of us and several projects running at the same time, I need to have enough around for everyone. 

I have a pile of simple bare...

View Post

HP 9825 Crowbar

curiousmarc post HP 9825 Crowbar from patreon

I wanted to keep the crowbar design for the last episode and grand-finale of our HP 9825 repair series, but this is dragging on as we have been distracted by Apollo stuff and the re-emergence of Covid, and have not completely repaired the tape board yet (although it's mostly up now thanks to Eric). 

However, one of...

View Post

The IBM IO Tester thinks it is a chronomter

curiousmarc post The IBM IO Tester thinks it is a chronomter from patreon

https://youtu.be/sv0nwF3uzUY

I just hooked up the restored IBM IO Tester blinkenlight panel to an Arduino to make it blink a bit...

Marc

View Post

Large IBM installation in the 1970s

curiousmarc post Large IBM installation in the 1970s from patreon

A tip from a viewer, this video has really neat footage of an IBM datacenter, an IBM 370 I presume. Gorgeous and iconic IBM terminals, the super duper 20,000 line per minute laser printer. Not sure if the tape drives are IBM, they look like compatibles to me. Enjoy, and bonus points to those that can identify the exact pieces...

View Post

HP 8568 RF Analyzer: Restoration within a restoration

curiousmarc post HP 8568 RF Analyzer: Restoration within a restoration from patreon

In previous posts, we explained that will need to retune our Apollo PM test receiver to the original Apollo CSM frequency, because its frequency had been changed to support another project, one of our best guesses being the Viking launch in 1974. 

Fortunately we found the manual a month ago, and it describes the in...

View Post

Quick IBM IO Tester Restoration

curiousmarc post Quick IBM IO Tester Restoration from patreon

You probably remember seeing us unbox this big gray box recently. It is a donation from viewer Brad Proffit (thanks Brad!). 

He did not know what it was, but Carl quickly identified it as an IBM IO Tester. It was a piece o...

View Post

My TI Silent 703 terminal is overclocked!

curiousmarc post My TI Silent  703 terminal is overclocked! from patreon

Next in our unboxing was the TI Silent 703 from eBay. This one started strong, printing its waterfall test with no problems, in eerie silence:

Still in local mode, I discovered it had two character width settings. One yielding ...

View Post

We made two good HP 4957A with two bad ones!

curiousmarc post We made two good HP 4957A with two bad ones! from patreon

You saw us unbox my HP 4957A in a previous video, and as expected, it did not even power up. This was a cheap non-working machine I got for parts. This was to help getting my other  "good" HP 4957A working. 

The "good" one was a clean machine, complete with all the application disks, documentation, and cables....

View Post

(Spoiler Alert) Good job Patreons on guessing the PS/2 fault

curiousmarc post (Spoiler Alert) Good job Patreons on guessing the PS/2 fault from patreon

Here are the results of the poll:

And you guys did pretty good, much better than the average commenter that thought it was a cap. Well the average commenter *always* tells me it's a cap, no matter how much I show and explain wh...

View Post

Original manual for our PM receiver found!

curiousmarc post Original manual for our PM receiver found! from patreon

Over the week-end, Mike, Marcel and I flew to a private collector that might have other items to help us with our Apollo comms restoration. The collector, who is super nice, is also very private and wishes to remain anonymous. While Mike was foraging in his many documentation shelves, he found this.

2021-10-27 21:25:09 +0000 UTC View Post

Place your bets on the PS/2 “planar” (motherboard) fault

Las Vegas time! Put in your bet! 

In Part 4 of our IBM PS/2 repair adventure, Eric changed the IO chip and finally got the “planar” to behave. But it worked only after he prodded it with his magic finger or put cold sp...

View Post

Apollo PM Test Receiver First Light

curiousmarc post Apollo PM Test Receiver First Light from patreon

I am falling further and further behind in my videos, but our current latest advance was to power up the PM test receiver. Previously we had done receive tests using an HP mixer to bring the microwave signal back down to an IF of 20 MHz, then I used my HF ham radio as an IF section and got the FM baseband out of it. Good enou...

View Post

Apollo Uplink Box Progress

curiousmarc post Apollo Uplink Box Progress from patreon

https://youtu.be/nALBEotYQzs 


You might remember our mystery uplink command box that we got from Marcel, completely undocumented, full of weir...

View Post

To the Moon and Back with the Apollo Transponder

curiousmarc post To the Moon and Back with the Apollo Transponder from patreon

Progress continues with our power up of the Apollo transponder. We achieved frequency locked turnaround transmission: from Earth to the Moon, then back. With Earth being simulated by the two antennas at the far end of the table attached to my growing pile of HP equipment, and Moon being the two antennas in the near corner att...

View Post